Demo mode
In Demo mode you can configure and transmit an internal test signal without connecting an external audio source.
Basic control
Section titled “Basic control”| Parameter | Description |
|---|---|
| Audio Mode | Switches between Demo, Analogue and Network Dante. |
| Start Demo / Stop Demo | Starts or stops the test transmission. |
| Status indicator | Shows the current mode and state. Red indicates a stopped transmission and green indicates an active transmission. |
| Audio level monitor | Displays the output audio levels while the stream is running. |
Stream configuration
Section titled “Stream configuration”| Parameter | Description | Values |
|---|---|---|
| Demo Stream Type | Sets the channel count and sample rate of the test stream. | 1 × 48 kHz · 1 × 24 kHz · 1 × 16 kHz · 2 × 48 kHz · 2 × 24 kHz · 3 × 16 kHz · 4 × 24 kHz · 6 × 16 kHz |
| Demo Content | Selects the transmitted test material. | Program material · 1 kHz test tone |
| Stream Password | Optionally protects the stream from unauthorised access. Leave the field empty for a public broadcast. |
Advanced transmission parameters
Section titled “Advanced transmission parameters”| Parameter | Description | Values |
|---|---|---|
| Assistive listening | Identifies the stream as assistive listening content for compatible receiving devices. | |
| Immediate rendering | Requests playback with the shortest possible delay at the receiver. | |
| Delay (ms) | Defines an additional playback delay in milliseconds. | |
| QoS | Prioritises robustness or low latency. | Robust · Fast |
| TX Power (R1/R2) | Sets the transmit power of the respective radio module. The maximum transmit power is +10 dBm according to the product datasheet. | max. +10 dBm |